Make sure to install whatever gaskets or washers that are included with the drain kit. What kind of screw do I use to secure the pan? If you need to, add extra concrete in the areas where it is needed so that the shower base is level when you put it into place. Measure the width and length of the sump on the back of your shower base and add an extra 20mm so that there is some room for the sump to move but also so that the base still fits snugly into the floor. Shower pans will vary some from manufacturer to manufacturer, but the basic steps are the same. Measure, cut and cement the final tailpiece to the P-trap.
When I install the bottom row of tile, do I need to use more caulk between the bottom of that row and the tub, or would that create a hazardous moisture trap? There is too much buffering. This shower door sweep is exactly what I needed so I ordered a spare in case I need another one. Do not use a grease pencil because it will show through the silicone and look dirty. It is imperative that you do not install plastic behind your walls since this would create two waterproof membranes with your substrate between them. Hi Lance, Any good modified thinset will work fine. I ended up separating it slowly with a box cutter then I used Goof Off and a rag to remove any residue.
Installing Cement Backerboard for Tile in a Shower
Alternatively, custom shower construction, although a somewhat laborious process, grants a builder greater freedom and has the ability to increase a home's appeal and value. Hi Roger, Question on this part: Do you just embed the walls in the pan? Roger, Do I need to put up Sheetrock before installing the backer board in a shower?
Description: My tile guy wants to use the method you describe with 10 minute building paper , but I am reading in a lot of places that this method is not long lasting and that using surface membrane or paint on eg. Using the same techniques as with the prepan mortar layer, run a straightedge over the mortar, correct any unevenness and create a smooth surface with a wooden float. A lot of professionals simply use galvanized roofing nails. You may be able to get better prices by ordering online but make sure you take shipping costs into consideration. Except the job or get a new tile guy to take down all tiles and cement board and redo the entire shower surround?